Solter TAPP-1300 Manual De Instrucciones página 17

DIGITAL MODELS
DESCRIPTION
1 - Selector.
2 - Fault Indicator
Arc reinforcement current (Ifor): MMA mode. This parameter configures the increase in peak cu-
3 -
rrent while welding to increase welding power by shortening the arc. The adjustment values vary from
0% to 25% of the increase over I1.
4 - Welding current (I1):
supply; this will depend on the electrode used. The setting limit lies between 10A and 200A (in accor-
dance with the model).
5 - Start current (Ihot):
of difficult electrodes. In this case the values vary from 0% to 25% of the increase over I1. After selec-
ting the % increase, you can determine the duration of Ihot.
6 - Units of measurement: A = Amps.
7 - Units of measurement: S = seconds.
8 - Units of measurement: % = percentage.
9 - Display.
10 - MMA weld mode indicator.
11 - TIG weld mode indicator.
5 4
I
I
1
hot.
6
A
7
S
8
%
9
TO SELECT THE WELDING MODE
Press 1 for 2 seconds. The display shows _ _ _. Turn 1 to select between MMA or TIG mode. Press 1 again
to accept your option.
TO MODIFY A PARAMETER
Turn Selector 1 to the right or to the left to select your welding parameters. The number of available parame-
ters depends on the welding mode selected. To modify a parameter, press selector 1 briefly until the LED in-
dicator flickers. Turn the selector to choose the welding parameters. Press 1 again to accept the change.
Some parameters can be double as, for example, the Ihot. In this case, the LED lights up to show two values:
Current in %, and Time in seconds.
PARAMETERS FOR MMA MODE
- I1 (A): Main welding current
- Ihot (%): Initial welding power expressed in % - which will be added to I1 (LED % lit).
- Thot (S): Parameter in which both the Ihot LED and the S (seconds) LED are lit. The time displayed will be
the time-value applied in the Ihot parameter.
- Ifor (%): Additional current that the unit will supply in case of short-circuit. Value expressed in % which will
be added to I1.
PARAMETERS FOR TIG MODE
- I1 (A): Welding current in Amps
FAULT LED
This LED lights up when there is a fault in the unit. It indicates either too low supply voltage or overheating.
The Fault Indicator might light up during a few seconds when the unit starts. The display will show Er1.
SOLTER
SOLDADURA S.L.
This parameter will introduce the current in amperes the equipment should
MMA mode. Determines the initial arc current (Hot Start), improving the start-up
3
2 1
I
.
for
10 11
INVERTER
EN
6