Names Of Parts; Preparation Before Using The Veil Diffuser; Pressing Down The Veil Potion Nozzle - SENSAI EH-ZKF02 Manual Del Usuario

0702̲説明書̲P6̲P7

Names of Parts

SENSAI BIOMIMESIS VEIL DIFFUSER (Main device)
Mode switch Indicator light
Off
0: Off
: Pass Liquid* mode
* See "Pass Liquid" on p. 11
Device cap VEIL POTION cover
Stand (accessory)
Nozzle stick* (accessory)
*The nozzle stick is clipped into the stand.
06
On
: Spray low
Blinking : Spray normal On
Mode switch Main switch
Release button
Batteries are not included.
Please purchase separately.
Eye guard (accessory)
SENSAI BIOMIMESIS VEIL POTION (sold separately)
Nozzle

Preparation Before Using the VEIL DIFFUSER

This device sprays a veil onto skin, and is to be used after inserting
a SENSAI BIOMIMESIS VEIL POTION (sold separately).

Pressing Down the VEIL POTION Nozzle

The VEIL POTION must be prepared by doing the following before inserting
it into the device.
Hold onto the nozzle and the hard section on top of the pouch, and press nozzle down firmly.
Battery cover
• Press down until the spaces between the grey and white sections are no longer visible.
Nozzle
Spaces
Press nozzle down
• Liquid will not dispense unless nozzle is pressed down.
• After pressing the nozzle down, insert the VEIL POTION into the VEIL DIFFUSER and
close the main device cap to store.
• Do not remove the nozzle.
Pouch
• Nozzle has sharp edges.
Take care to avoid injuring fingers.
[Parts of the VEIL POTION to be held in hand]
Nozzle
Hard section
Spaces are no longer visible
[Note]
• After pressing down the VEIL POTION nozzle, use
all contents promptly (within approx. three months).
If stored for too long, dryness may cause the liquid
to harden, resulting in blockages.
• To avoid blockages due to dryness, use each VEIL
POTION at least once per month after pressing the
nozzle down, or allow liquid to pass through the tip
of the nozzle. *See "Pass Liquid" on p. 11
07