When The Veil Does Not Spray Properly - SENSAI EH-ZKF02 Manual Del Usuario

0702̲説明書̲P16̲P17
When Veil Does Not Spray Properly
Check the batteries
Check if the indicator light turns on.
• Set the mode switch to 2 and press the main
switch to check that the indicator light turns
on. If it does not, replace with new batteries.
*See "Inserting the Batteries" on p. 08
Check if veil sprays.
• Set the mode switch to 2 and press the main
switch to check if the veil sprays.
If veil still does not spray after replacing
the batteries, follow the steps below.
Pass liquid
*See "Pass Liquid" on p. 11
Clean the nozzle tip.
• Use a tissue to wipe the nozzle tip clean.
Pass the liquid to check if liquid comes out.
• Set the mode switch to the droplet symbol
( ) and press the main switch for about one
minute to see if any liquid comes out.
• If liquid comes out, set the mode switch to
2 and press the main switch to check if veil
sprays from the device.
If no liquid comes out after trying to pass liquid,
or if veil has difficulty spraying, follow the "Use the
Nozzle Stick" instructions on p. 17.
16
Use the nozzle stick
Set the mode switch to 0 (OFF).
Grasp the nozzle stick
clipped inside the stand
Nozzle stick
and slide upwards to
remove.
Clean the hole of the nozzle with the
nozzle stick.
Insert the nozzle stick straight into the tip and
move in-and-out three or four times.
• Do not use any object (like a needle, etc.)
other than the nozzle stick. Doing so may
cause the device to malfunction.
• Use a tissue to wipe away hardened liquid or
any other substance from the nozzle stick.
Pass liquid and check if veil sprays.
If veil still does not spray properly,
see "Troubleshooting" on p. 20~21.
Stand
17