Inserting The Veil Potion; Inserting The Batteries; Product Features And Cautions - SENSAI EH-ZKF02 Manual Del Usuario

0702̲説明書̲P8̲P9
Preparation Before Using the VEIL DIFFUSER

Inserting the VEIL POTION

Check to ensure the mode switch is set to 0 (OFF).
Press down on both sides of the cap
to remove it from the device body.
VEIL POTION cover
Insert the VEIL POTION into the
device's VEIL POTION slot as shown.
VEIL POTION slot

Inserting the Batteries

Check to ensure the mode switch is set to 0 (OFF).
Remove the battery cover.
Check the +/- poles and insert the batteries from the - end.
Replace the battery cover.
• Uses two AAA alkaline batteries (LR03).
• Check to ensure the +/- poles of the batteries do not have anything attached. • Use only AAA alkaline batteries. Using
batteries other than those specified may cause a change in power or number of times device can be used. • We
recommend using Panasonic batteries. • Do not use rechargeable batteries. • When replacing batteries, change both at
the same time. • Do not replace batteries with wet hands. • Do not recharge non-rechargeable batteries. • When using
the device, do not mix different types of batteries or new and used batteries. • Remove exhausted batteries from the
device and dispose safely. • Remove batteries if the device is not used and stored for a long period. • Do not short circuit
the supply terminals.
08
Then press the release button and
remove the VEIL POTION cover.
Device cap
Release button
Close the VEIL POTION cover until
it clicks.
Click
• Batteries sold separately.

Product Features and Cautions

(continued)
Device mechanism: Uses the potential difference between
positive and negative electrical charges to spray a single long
thread that weaves itself into a veil on top of skin.
A person's body (including the face) takes on a negative electrical charge
when they touch the main switch and grounding plate. The veil has a positive
charge, so it is attracted to the face and sprays on cleanly.
[Note]
• Higher areas of the face, like the eyelashes and nose, tend to
easily attract veil thread. Take extra care to avoid nose and
eyes when spraying.
[Caution]
• Keep touching main switch and grounding plate while using
the device.
• The nozzle takes on a positive charge while the device is
running and immediately after. Do not touch. (Touching the
nozzle will generate static electricity and cause a small
electric shock.)
In order for the VEIL POTION to form a perfect veil, the liquid transforms
into a stringy substance when sprayed. This characteristic makes
the liquid prone to hardening due to dryness.
To avoid hardening and blockage due to dryness...
• After pressing down the VEIL POTION nozzle, use all contents promptly (within approx. three months).
• After use, wipe the nozzle clean and close the device cap firmly.
• Set inside the special stand to store. If the device is not stored upright, liquid may harden in the tip of
the nozzle and cause blockage.
• When not using for long periods, we recommend occasionally (approx. once per month) letting liquid
pass through the tip of the nozzle (liquid-passing). *See "Pass Liquid" on p. 11
Main switch
Enlarged image of veil VEIL POTION
Nozzle
Grounding plate
09