Mantel/Top; Left Back Panel - Twin-Star International 23MM705 Manual De Instrucciones Adjunto

8. Then locate Mantel/Top (G) and lay finish
side up on top of completed assembly from
step 7. From the inside attach the Mantel
using Bolts (L) and Washers (M) through
the pre-drilled holes in the side panels and
mounting blocks
HAND TIGHTEN ONLY.
9. Using Phillips head screwdriver tighten all
Bolts alternating top and bottom, left and
right.
10. Locate Left Back Panel (I), attach to the
left back of the completed assembly from
step 9, using a Phillips Head screwdriver,
tighten screws (Q) through the pre-drilled
holes in the Left Back Panel to the
completed assembly.
11. Locate Right Back Panel (P), attach to the
right back of the completed assembly from
step 9, using a Phillips Head screwdriver,
tighten screws (Q) through the pre-drilled
holes in the Right Back Panel to the
completed assembly.
12. Locate Center Back Panel (R), attach to
the center back of the completed assembly
from step 9, using a Phillips Head
screwdriver, tighten screws (Q) through the
pre-drilled holes in the Center Back Panel
to the completed assembly.
E-4

Mantel/Top

N
N
N
P
Right
Back
Panel
G
N
M
L
Screw
Q
I
R
N
I
Left
Back
Panel