Conceptronic C150BRS4 Manual Del Usuario página 46

ENGLISH
Single Port Forwarding

Select „Single Port Forwarding‟ in the advanced menu bar at the left.
The „Single Port Forwarding‟ configuration will be shown on your screen:
Note: In the picture above, you will see an example of some port forwarding rules.
You can define up to 10 single port forwarding rules in the wireless router.

Enter the information needed for the port forwarding in the following fields:
- External Port : Enter the port which must be visible on the outside of your internet connection.
- Internal Port : Enter the desired local port for the computer/device.
- IP Address
- Protocol
- Enable
- Delete
Note: If you do not know which protocol („Type‟) you need to select for your virtual server rule, select
„Both‟. This option will pass both TCP and UDP traffic through to the configured IP address.
When you have configured the rules, click "Apply" to save the port forwarding configuration.
Note: To make sure the configured rules will work correctly, it is recommended to reboot your router
after you have configured your port forwarding rules.
46
: Enter the local IP address of the computer/device.
: Select the type of type of network traffic that should be passed through.
: Enable or disable the configured rule.
: Delete the configured rule.