Back Panel; Connecting The Cables; Wan Port; Lan Port(S) - Conceptronic C150BRS4 Manual Del Usuario

2.2 Back panel

Nr Description
A Power connection
B

WAN port

C LAN ports (1 – 4)
D Reset button
E WPS button
F Wireless antenna connector
Connect the power supply to the power connection on the back of the wireless router and to an available
wall socket. The power LED on the front of the wireless router will lit up.
3.1 WAN port
Use a network (LAN) cable to connect the wireless router to your broadband modem.
The WAN LED on the front of the wireless router will lit up.
Note: If the WAN LED on the front does not lit up, make sure that:
- The wireless router is powered on (the power LED should burn).
- The broadband modem is turned on.
- The network (LAN) cable between both devices is connected correctly.

3.2 LAN port(s)

Connect the network (LAN) cable to 1 of the 4 LAN ports on the back panel of the wireless router and to
the network card of your computer.
The LAN LED of the used LAN port will lit up, indicating that the computer is connected. (Your computer
must be switched on and the LAN connection must be enabled).
Explanation
Connect the power supply to the router
Connect your broadband connection to the router
Connect your computer(s)/network device(s) to the router
Perform a reset (hold)
Activate WPS function (short press)
R-SMA connector for wireless antenna connection

3. Connecting the cables

ENGLISH
27