Conceptronic C150BRS4 Manual Del Usuario página 47

Port Range Forwarding

Select „Port Range Forwarding‟ in the advanced menu bar at the left.
The „Port Range Forwarding‟ configuration will be shown on your screen:
Note: In the picture above, you will see an example of some port forwarding rules.
You can define up to 10 port range forwarding rules in the wireless router.

Enter the information needed for the port forwarding in the following fields:
- Start Port
- End Port
- IP Address
- Protocol
- Enable
- Delete
Note: If you do not know which protocol („Type‟) you need to select for your virtual server rule, select
„Both‟. This option will pass both TCP and UDP traffic through to the configured IP address.
When you have configured the rules, click "Apply" to save the port forwarding configuration.
Note: To make sure the configured rules will work correctly, it is recommended to reboot your router
after you have configured your port forwarding rules.
: Enter the first port of the range which must be forwarded to your computer.
: Enter the last port of the range which must be forwarded to your computer.
: Enter the local IP address of the computer/device.
: Select the type of type of network traffic that should be passed through.
: Enable or disable the configured rule.
: Delete the configured rule.
ENGLISH
47