Sime SOLIDA EV 3 Instrucciones De Instalación Y Mantenimiento página 32

1 MAIN WARNINGS
The instruction manual is an integral part
of the product and must be delivered to the
user. Carefully read the warnings contained
in the manual on installation, use and main-
tenance of the appliance. Carefully store
the manual for future reference.
Installation must be carried out by qualified
personnel in compliance with the stan-
dards in force and following the instruc-
tions provided by the manufacturer. Impro-
per installation can damage persons or
objects, which the company is not responsi-
2 SUPPLY
As indicated in fig. 1, the boiler is supplied in
two different packaging:
– Cast iron boiler body with flue gas cham-
ber and adjusting dampers, ash collec-
ting tray and draught thermostatic regu-
lator. A bag containing: 2 handles for the
ports, one screw with bakelite knob for
manually adjusting the air gate dumper,
a contact spring for the thermometer
bulb and a M6 lever to be fastened to
the air gate dumper. "Test report" and
32
ble for.
Ensure that the product is intact. In case of
doubt, do not use the appliance and con-
tact the supplier. Packaging components
must be disposed of in compliance with the
standards in force.
Before any maintenance operation on the
appliance, disconnect the power supply
using the system switch.
In case of failure or malfunction, deactivate
"Declaration of conformity" to be stored
together with the documents of the boi-
ler.
– Carton packaging with casing, thermo-
meter and document kit. The document
kit includes: instruction manual, warranty
certification, BOILER TECHNICAL DATA
plate and label module to apply on the
declaration of conformity.
ATTENTION: The BOILER TECHNICAL
1
the appliance avoiding any repair or direct
intervention. Only refer to qualified techni-
cal personnel. Any repair must be carried
out by using original spare parts only.
Failure to comply with that above can com-
promise the integrity of the system and sin-
gle components, being a potential danger
for the user's safety, which the company is
not responsible for.
Maintenance of the appliance and chim-
ney is required at least once a year.
DATA plate included in the document kit is
adhesive and must be applied on a side of
the casing by the installer.
The serial number of the iron case body is
indicated on the riveted plate on the rear
upper side of the body.
To facilitate transport, the load and drain
of the boiler are placed on the upper side
and are equipped with lifting hooks.
2
Fig. 1