Cleaning And Storage; Troubleshooting - EAS ELECTRIC EHH201 Manual De Instrucciones

CLEANING AND STORAGE

It is recommended that the heater be cleaned at least one time during the
operating season in order to provide the optimum level of performance.
ALWAYS TURN THE POWER SWITCH OFF AND UNPLUG THE HEATER
BEFORE CLEANING. Be sure to save the box for off-season storage.
 Turn the heater "OFF", unplug it and wait for the heater to cool down.
 Use a dry cloth to clean only external surfaces of the heater.
 Do not use any cleaning agents or detergents.
 Never immerse the heater in water.
 Pack the heater in the original carton and store it in a cool and dry pla-
ce.
 Avoid bruising or scratching products to avoid surface coating damage
and rust.

TROUBLESHOOTING

If your heater fails to operate, please follow these instructions:
 Ensure that your circuit breaker or fuse is working properly.
 Be sure the heater is plugged in and that the electrical outlet is working
properly.

Check for any obstruction. If you find any obstruction, turn the heater
"OFF". Unplug the heater and wait a few minutes for it to cool down.
Carefully remove the obstruction. Plug the heater in and turn it on again
by referring to the OPERATING INSTRUCTIONS.
Note: If you have a problem with the heater, please refer to the warranty
conditions. Do not attempt to open or repair the appliance yourself, as doing
so may invalidate the warranty and may cause damage or injury. If the
problem persists, contact the after-sales service for assistance.
8 V.1