Display Indications; Stopwatch Function - Bohle TwinLED Verifix BO 5500355 Manual De Instrucciones

06 Display Indications
The following information is displayed on the
TwinLED display:
1 Name of the timer chosen
2 State of the LED (on/off)
3 Battery level
4 Current time of the chosen timer
5 Wavelength of the chosen LED
07 Switching the LED ON/OFF
Press the key for switching the LED on.
By pressing the
off.
Please note: Depending on the timer function
chosen, a specific time has to be set first before
switching the LED on.
Please note: If the battery is completely empty,
the LED cannot be switched on. In this case, please
charge the battery first.
08 Choosing the Wavelength
Press and hold the
By shortly pressing the
between the two wavelengths.
Please note: The wavelength can only be changed
while the LED is switched off.
14
key again, the LED is switched
key.
key, you can choose
09 Choosing the Timer
Press and hold the
By shortly pressing the
functions are displayed one after the other.
Please note: The timer function can only be
changed while the LED is switched off.
10 Working with the
Stopwatch Function
The stopwatch function serves to easily determine
the curing times for a specific application.
Press the key for switching the LED on and for
starting the stopwatch.
During its operation, the LED can be switched off
any time by pressing the
and remains in the value displayed at this moment.
When the LED is switched on again, the stopwatch
resumes counting from the time last displayed.
Alternatively the stopwatch can be reset to 0:00
while the LED is switched off by shortly pressing the
key.
Please note: After a maximum of 10 minutes
of permanent operation, the LED will switch off
automatically.
key.
key, the four timer
key. The time stops