Bohle TwinLED Verifix BO 5500355 Manual De Instrucciones página 15

11 Adjusting the Single Timer
By pressing the or
time of the timer can be set.
By pressing and holding the
time can be counted up or down.
12 Adjusting the Timer for
Pre- and Final Curing
The timer for pre- and final curing can not be directly
adjusted via the or
For setting the corresponding curing times, first
press and hold the
key in order to change into the programming
mode (display of the timer name in [square
brackets]).
Then the operating time of the timer chosen can be
adjusted by pressing the
By pressing and holding the
time can be quickly counted up or down.
The programming mode is abandoned and the set
time saved by shortly pressing the
keys, the operating
or keys, the
keys.
key and shortly press the
or keys.
or keys, the
key.
13 Working with Timer
Functions
The timer functions serve for repetitive batch
bonding with previously determined and adjusted
light exposure times.
Press the key for switching the LED on and for
starting the timer.
When the preset time has expired, the LED switches
off automatically. If necessary, the LED can be
switched off while the timer is still operating, by
pressing the key again. As a result, the timer
stops and remains in the value displayed at this
moment. When the LED is switched on again, the
timer resumes counting from the time last displayed.
Alternatively, the timer can be reset to its original
value while the LED is switched off by shortly
pressing the key.
Please note: In order to use one of the timer
functions, a specific time must be programmed first.
Please note: When choosing the pre- or final curing
timer functions, the device automatically changes
into the next function once the first time set has
expired.
14 Fixing the Lamp
The TwinLED has different fixing holes (1/4" UNC
tripod socket).
In this way the TwinLED can be fixed to existing
constructions, e.g. with the supplied screws.
EN
15