Declaration Of Conformity; Fcc Information - Mitsubishi Electric LDT322V Manual Del Usuario

Tabla de contenido

Idiomas disponibles

Important Information

This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions. (1) This device may

not cause harmful interference, and (2) this device must accept any interference received, including interference that may

cause undesired operation.

U.S. Responsible Party: Mitsubishi Digital Electronics America, Inc.

Address:

Tel. No.:

Type of Product:

Equipment Classiﬁ cation: Class B Peripheral

Model:

conforms to the technical standards as speciﬁ ed in the FCC Rules.

Windows is a registered trademark of Microsoft Corporation. All other brands and product names are trademarks or reg-

istered trademarks of their respective owners.

Canadian Department of Communications Compliance Statement

DOC: This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regula-

tions.

C-UL: Bears the C-UL Mark and is in compliance with Canadian Safety Regulations according to CAN/CSA C22.2 No.

60950-1.

FCC Information

1. Use the attached speciﬁ ed cables with the LDT322V (BH820) color monitor so as not to interfere with radio and television

reception.

(1) Please use the supplied power cord or equivalent to ensure FCC compliance.

(2) Please use the supplied shielded video signal cable, 15-pin mini D-SUB to 15-pin mini D-SUB.

2. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the

FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This

equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will

not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•

Consult your dealer or an experienced radio/TV technician for help.

If necessary, the user should contact the dealer or an experienced radio/television technician for additional suggestions.

The user may ﬁ nd the following booklet, prepared by the Federal Communications Commission, helpful: "How to Identify

and Resolve Radio-TV Interference Problems." This booklet is available from the U.S. Government Printing Ofﬁ ce,

Washington, D.C., 20402, Stock No. 004-000-00345-4.

All manuals and user guides at all-guides.com