Klarstein SKYSCRAPER HEAT Manual De Instrucciones página 23

Setting the time (press this key once in working condition)
• The time indicator
second. At this time press the „UP (+)" and the „DOWN (-)" key to set
the timer (within a range of 1-12 hours), the timer will add or subtract
1 h with every press.
• Enter into the timer setting mode, the timer that has been set before
can not be changed. You can reset the time, only when pressing „UP
(+)" and „DOWN (-)" key.
• If the timer turns to value 0, then the device will turn off at once, and
enter into stand- by mode.
• Press SET key, the timer setting is finished, and enter into
temperature setting.
Setting the temperature (press this key twice in working conditition)
• The light indicator
You can change the temperature by pressing the „UP (+)" and „DOWN
(-)" key. The range of tempera- ture is from 15 to 28 °C.
• Press SET key to quit temperature setting, and the temperature that
you have set will be effect at once.
• If no operation to the keys after 5 seconds or press other keys except
„UP (+)" and „DOWN (-)" then the LED indicator will show room
temperature.
Functioning of temperature and timer function
• If the temperature is -10 °C, then it will show "LO". If the temperature is over
40 °C, then it will show "HI".
• The device will not judge the temperature within 10s when power on the
device. After the device work for 10s, if the ambient temperature reaches or
over the temperature that has been set, the heating function will turn off, the
low/high heating power light will be off, and the fan will be off in 10 seconds.
If you have pressed Swing, it will turn off as well. For the other indicators will
not change.
• If the ambient temperature decreased, and 2 °C lower than the temperature
that has been set, the heat- ing function will be on again, as well as the fan
& the swing function (if you have pressed Swing before). Also the other
indicators will be on.
• If the ambient temperature reaches or over the automatically setting
temperature 25 °C, then the device will work when you set the temperature
over 25 °C.
• When setting the time & temperature at the same time, it will show in a circle,
time show 30 seconds, and not show temperature. Then the temperature is
shown for 30 seconds instead of the time. If you do not set the timer or set the
timer to 0, then time will not show.
will be on. The light will flicker twice per
will be on. The LED will flicker twice a second.
EN
23