Starting Operation; Working Advice; Maintenance And Service - Bosch IXO Serie Manual Original

Fitting the application tool (see figure C)
Pull the locking sleeve (3) forwards, guide the application tool into the tool
holder (2) as far as it will go, then release the locking sleeve (3) to lock the
application tool in place.
Operation

Starting Operation

IXO (3 603 JA8 0.., 3 603 JC7 0.., 3 603 JC7 1..) (see figures D1 and
D2)
Clockwise: To drill and to drive in screws, slide the rotational direction
switch (5) all the way to the front.
Anti-clockwise rotation: To loosen or unscrew screws, slide the rotational
direction switch (5) backwards.
IXO (3 603 J81 0.., 3 603 J59 1.., 3 603 J59 3..) (see figure D3)
Right rotation: To drill and to drive in screws, press the rotational direction
switch (5) through to the left stop.
Left rotation: To loosen and unscrew screws, press the rotational direction
switch (5) through to the right stop.
Switching on/off
To start the power tool, press and hold the on/off switch (6).
To switch off the power tool, release the on/off switch (6).

Working Advice

Only apply the power tool to the screw when the tool is switched off.
u
Rotating application tools can slip off.

Maintenance and Service

Maintenance and Cleaning
Keep the drilling adapter clean to ensure good, safe operation.
u
Remove the drilling adapter from the screwdriver to clean it. There is
u
risk of injury from unintentionally pressing the on/off switch.
Bosch Power Tools
English | 15
1 609 92A 5M1 | (09.04.2020)