Establishing A Connection To The Wlan Router Via Wps (Router/Cloud Mode) - Oase InScenio EGC Controller Home Instrucciones De Uso

2
Use the button
InScenio EGC Controller is connected to the available WLAN of a router. The smartphone/tablet has to
be connected to the same WLAN.
(→ Establishing a connection to the WLAN router via WPS (router/cloud mode))
(→ Manually establishing a connection to the WLAN router (router/cloud mode))
Network name (SSID)
Indicates the WLAN to which the InScenio EGC Controller is connected.
Cloud connection
Use the touch symbol
disconnect it. (→ Activating the cloud connection)
Connection status
InScenio EGC Controller Cloud is connected to the OASE cloud.
InScenio EGC Controller Cloud is not connected to the OASE cloud.
3 Device password
A new device password is entered using the touch symbol
word in order to change it.
4 System settings
Use the touch symbol
operating device.
The firmware is updated via the touch symbol
It is necessary to enter the current password in order to carry out an update.
5 Display of the device information
7.3.1

Establishing a connection to the WLAN router via WPS (router/cloud mode)

"Settings" screen
Prerequisite:
The smartphone/tablet is directly connected to the InScenio EGC Controller (access point mode).
(→ Establishing a direct WLAN connection (access point mode))
Compatibility with the following WLAN standards: 802.11n+g+b
Exclusively in the frequency range 2.4 GHz.
How to proceed:
1. Tap
2. Select "WPS" in the query.
WPS is activated. Activate WPS on the WLAN router within 2 minutes. Read the router instructions if neces-
sary.
The connection is established when the LED on the InScenio EGC Controller flashes green slowly (2 sec-
onds on, 1 second off).
3. Connect the smartphone/tablet to the WLAN of the router.
The app "OASE Easy Control" can now connect to the InScenio EGC Controller via the router.
InScenio EGC Controller can now be controlled using the "OASE Easy Control" app.
to start the InScenio EGC Controller in router/cloud mode. In this mode, the
to connect the InScenio EGC Controller Cloud to the OASE cloud or to
to update the system time of the InScenio EGC Controller to the time of the
.
. It is necessary to enter the current pass-
.
- EN -
55