OBJ_BUCH-2386-001.book Page 15 Monday, February 9, 2015 11:37 AM
Portable Radio
Audio Operation/Radio
Operating voltage
– for operation with power-supply plug
– for battery-pack operation
Rated output of amplifier (for operation with power-supply plug)
Reception range
– FM
– AM (3 603 JA9 0.. (EU))
– AM (3 603 JA9 04. (AUS/NZ))
1) Bluetooth® devices must support the A2DP profile.
2) depending on the battery pack being used
* Limited performance at temperatures <0 °C
Power-supply plug
Article number
Input voltage
Frequency
Input current
Output voltage
Output current
Weight according to
EPTA-Procedure 01/2003
Protection class
Declaration of Conformity
We declare under our sole responsibility that the product de-
scribed under "Technical Data" complies with all applicable
provisions of the directives 1999/5/EC, 2004/108/EC,
2006/95/EC, 2009/125/EC, Regulation (EC) No.
278/2009, 2011/65/EU including their amendments and is
in conformity with the following standards:
EN 60065:2002-05 + A1:2006-05 + A2:2010-10 +
A11:2008-11 + A12:2011-02,
EN 300 328 V1.8.1:2012-06,
EN 301 489-1 V1.8.1:2008-04,
EN 301 489-1 V1.9.2:2011-09,
EN 301 489-17 V2.2.1:2012-09, EN 62479:2010-09,
EN 55013:2013-06, EN 55020:2007-01 + A11:2011-10,
EN 61000-3-2:2006-04 + A1:2009-07 + A2:2009-07,
EN 61000-3-3:2013-08.
Technical documents at:
Robert Bosch GmbH, PT/ETM9,
70764 Leinfelden-Echterdingen, GERMANY
12
Henk Becker
Helmut Heinzelmann
Executive Vice President
Head of Product Certification
Engineering
PT/ETM9
Robert Bosch GmbH, Power Tools Division
70764 Leinfelden-Echterdingen, GERMANY
Leinfelden, 12.01.2015
Bosch Power Tools
Assembly
1 600 A00 0..
Opening/Closing the Storage Compartment
V~
100–240
Fold the rod antenna 23 out of its holder. Then open the lock-
Hz
50/60
ing latch 4 of the storage compartment and fold open the lid
mA
500
27.
V=
12
Note: Close the lid of the storage compartment and lock it
using the latch 4 when operating, transporting or storing the
mA
1500
radio. Otherwise, the radio may become damaged.
kg
0.2
Power Supply of Radio
/II
The radio can be powered using the power-supply plug 31 or
using a Li-Ion battery 33.
Operation with Battery Pack (see figures A–B)
Note: The use of batteries unsuitable for your radio can lead
to malfunction or damage to the radio.
Note: The battery pack is supplied partially charged. To en-
sure full capacity of the battery pack, completely charge the
battery pack in the battery charger before using for the first
time.
Use only the chargers listed in the technical data. Only
The lithium-ion battery can be charged at any time without re-
ducing its service life. Interrupting the charging procedure
does not damage the battery.
To insert a battery, open the lid 27 of the storage compart-
ment.
– Operation with 10.8 V battery: Insert a 10.8 V battery in-
– Operation with 14.4/18 V battery: Place a 14.4 V bat-
The battery charge-control indicator b appears on the display
as soon as a battery with sufficient voltage is inserted and the
radio is not connected to the mains by the power-supply
plug 31.
V
V
MHz
kHz
kHz
these chargers are matched to the lithium-ion battery of
your radio.
to the battery port 24 so that the terminals of the battery
rest on the terminals in the battery port 24. Allow the bat-
tery to engage in the battery port.
tery or an 18 V battery on the battery receptacle 25 so that
the terminals of the battery rest on the terminals of the bat-
tery receptacle 25. Slide the battery onto the battery re-
ceptacle until it engages.
English | 15
PRA MultiPower
12
10.8/14.4/18
2 x 3.5 W
87.5–108
531–1602
522–1611
1 609 92A 12F | (9.2.15)