Troubleshooting - Ryobi P2200 Manual Del Operador

pRoblEM
Line will not advance when
using the auto-feed head
Grass wraps around boom
housing and string head
Motor fails to start when switch
trigger is depressed

TRoUblEshooTINg

possIblE CAUsE
Line is welded to itself.
Not enough line on spool.
Line is worn too short.
Line is tangled on spool.
Cutting tall grass at ground
level.
Battery is not secure.
Battery is not charged.
For any questions about operating or maintaining your product,
Your product has been fully tested prior to shipment to ensure
your complete satisfaction.
13 — English
Lubricate with silicone spray.
Install more line. Refer to line Replacement earlier
in this manual.
Pull line while pressing button.
Remove line from spool and rewind. Refer to line
Replacement earlier in this manual.
Cut tall grass from the top down to prevent wrapping.
To secure the battery pack, make sure the latches
on each side of the battery pack snap into place.
Charge the battery pack according to the instructions
included with your model.
CALL US FIRST
call the Ryobi Help Line!
®
solUTIoN