Operating Conditions; Installation - PYD Electrobombas SUB Serie Manual De Instalación Y Mantenimiento

INSTALLATION AND MAINTENANCE MANUAL
SUBMERSIBLE PUMPS
Thank you for choosing our product. Please read the manual carefully before installation.

1. OPERATING CONDITIONS

1. Operating conditions
Standard construction
- For clean water with a maximum temperature of 35°C and a maximum content of 60
g/m3.
- Minimum internal diameter of the well: 132 mm.
- Minimum immersion depth: 100 mm.
- Maximum immersion depth: 20 m (with cable length).
- Maximum start-up time: 30 at regular intervals. Sound pressure at minimum immer-
sion depth: <70 dB (A).
The noise disappears when the pump is submerged.
Do not use in ponds, tanks or swimming pools where people may enter
or come into contact with water.
If at any time in the future you need to dispose of this product or any
part of this product, please note that electrical products, batteries or
cables should not be disposed of with household waste. Please recycle
where suitable recycling facilities exist, consult your local authority for
recycling advice.
Abandonment or uncontrolled disposal of waste can cause damage to
the environment and human health. Therefore, by recycling this product
responsibly, you are contributing to the preservation of natural resour-
ces and the protection of human health.

2. INSTALLATION

Construction Construction Construction Construction
without float switch without float switch with float switch with float switch
www.proindecsa.com / proindecsa@proindecsa.com
The inner diameter of the delivery pipe must
never be smaller than the diameter of the
pump connection port: G 1 1⁄4(DN 32).
The pump must be installed vertically with
the delivery port facing upwards. The pump
can be installed submerged (min 100 mm) or
submerged (max. 20 m), either resting on a
bottom surface or suspended.
13