Remington WDF4840 Manual De Instrucciones página 6

ENGLISH
• Do not rinse with water hotter than 70°C.
• Do not completely submerge the lady shaver in water.
• Do not clean the shaving foils with the brush.
• At regular intervals, put a drop of sewing machine oil onto the foils and
cutter heads.
, REPLACING YOUR FOIL AND CUTTERS
• To ensure the continued highest quality performance from your shaver, we
recommend that the foil and cutter are replaced every 6 months. These can
be obtained from our nearest Remington* Service Centre
, Signs that your foils and cutters need replacing.
• Irritation: as foils get worn, you may experience skin irritation.
• Pulling: as the cutters wear, your shave may not feel as close and you may feel
the cutter pulling your hair.
• Wear through: you may notice that the cutters have worn through the foils.
, TO REPLACE THE FOIL
• Ensure the lady shaver is switched off.
• Gently push the small plastic area at either end of the foil. The foil should
then easily detach from the head assembly.
• To reassemble, slide the foil into foil bracket and click into position.
• Close the head assembly
, CAUTION
• Only hold the plastic to prevent damage to the foil.
• Do not press on the foil when replacing.
, TO REPLACE THE CUTTERS
• Ensure the shaver is switched off and open the head assembly (as above).
• To remove cutter, grasp cutter between the thumb and forefinger and pull
upwards.
• To reassemble cutter, place cutter onto the oscillator tip. Gently push down
clicking into position.
< BATTERY REMOVAL
• The battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the mains supply when removing
the battery.
• Remove the shaver head from the unit.
6