Preparation; Clearances; Dimensions; Rollers - GE TBG24JABGRWW Manual Del Usuario

Clearances

Allow the following clearances for ease of installation, proper air
circulation and plumbing and electrical connections:
Sides ..........................................................................19 mm
Top.............................................................................25 mm
Back...........................................................................25 mm
If Model 19, 22, or 25 is to be installed against a wall on the hinge side,
allow 38 mm for door clearance.

Rollers

Some models have adjustable rollers that allow you to move the
refrigerator away from the wall for cleaning. Rollers should be set so
the refrigerator is firmly positioned on the floor and the front is raised
just enough (about 19 mm from the floor) that the doors close easily
when opened about halfway.
Remove the base grille by
grasping the bottom of the grille
and pulling it out.
When You Go on Vacation
For shorter vacations, remove perishable foods and leave controls at
regular settings. However, if room temperature is expected to drop
below 16°C, follow the same instructions as for extended vacations.
For extended vacations or absences, shut off the power to the
refrigerator, move the fresh food control to the "0" position, and
clean the interior with a baking soda solution of 15 ml of baking soda
to one liter of water. Wipe dry. To prevent odors, leave an open box of
baking soda in the refrigerator. Leave doors open.
Move icemaker feeler arm to STOP (up) position and be sure to shut
off water supply to the refrigerator.

Dimensions

Model 18
A* 163 cm 163 cm
B 75 cm 75 cm
C** 80 cm 83 cm
D 147 cm 147 cm
E 70 cm 70 cm
* Height does not include hinge—Add 22 mm for hinge.
** Depth includes handle.

PREPARATION

19 21
168 cm
79 cm
80 cm
152 cm
70 cm

Water Supply to Icemaker

If your refrigerator has an icemaker, or if you plan to add an
icemaker later, the icemaker will have to be connected to a cold
drinking water line.
A water supply kit containing copper tubing, shutoff valve, fittings
and instructions is available at extra cost from your local distributor.
There should be sufficient tubing from the cold water supply to the
icemaker inlet to allow moving the refrigerator out from the wall
several feet (approximately 244 cm of 1/4" copper tubing in three
25 cm diameter coils).
Do not use kits with plastic tubing since there is water pressure in the
supply line at all times.
Maximum permissible inlet water pressure—8.3 bars.
Minimum permissible inlet water pressure—1.4 bars.
Installation of icemaker must be made by a qualified service technician.
Turn the two front roller adjusting screws
clockwise to raise the refrigerator,
counterclockwise to lower it.
To replace the base grille, line
up the clips on the back of the
grille with the openings in the
base plate and push the grille
forward until it snaps into place.
When You Move
Disconnect power cord from wall outlet, remove all food, and clean
and dry the interior.
Secure all loose items such as grille, shelves and storage pans by
taping them securely in place to prevent damage.
Be sure refrigerator stays in upright position during actual moving and
in van. Refrigerator must be secured in van to prevent movement.
Protect outside of refrigerator with blanket.
22 24
168 cm 170 cm
79 cm 87 cm
83 cm 80 cm
152 cm 160 cm
70 cm 70 cm
(on some models)
25
170 cm
87 cm
A
83 cm
160 cm
70 cm
B
C
E
D
11