GE TBG24JABGRWW Manual Del Usuario página 17

REVERSE HARDWARE ON CABINET
1
TRANSFER BOTTOM HINGE BRACKET TO THE LEFT.
a. Remove the base grille. Grasp it at the bottom
and pull it straight out.
Bottom right
b. Using a Torx Driver, remove the hinge bracket
and plastic washer from the bottom right side
of the cabinet.
Plastic washer
c. Reinstall the hinge bracket and plastic
washer to the bottom left side of the cabinet.
Plastic washer
Bottom left
2
TRANSFER CENTER HINGE BRACKET TO THE LEFT.
a. Remove the center hinge bracket by removing
the three Torx screws.
NOTE: Keep these screws with the hinge
bracket. They are long screws and will be used
when installing the hinge on the other side.
On some models, you will need to remove the
color-matched caps from the screw heads before
you can remove the screws. Use the edge of a thin
flat blade to gently pry the caps off the screw
heads. (A putty knife works well for this.) Cover
the blade with tape to prevent scratching the paint.
b. Remove the three Torx screws from the center
left side of the cabinet. Screw them into the holes
on the right side.
Place the center hinge bracket over the holes at
the center left side of the cabinet. Insert and
tighten the three long screws.
c. Replace the caps by snapping them over the
screws with your finger.
3
TRANSFER TOP HINGE TO THE LEFT.
Interchange hinge and screws at top right with
screws at top left of cabinet. Do not tighten
screws on hinge side at this time.
4
TRANSFER DOOR STOPS.
a. On each door, move the metal door stop from
the right end to the left end.
b. Move any screws from the left end to the
right end.
(continued next page)
17