HIKVISION DS-PD1-MC-WWS Manual De Instrucciones

DS-PD1-MC-WWS
EN50131-2-6:2008
Partcode: MC1MINI-WE
EN50131-5-3:2005+A1:2008
PD6662:2010
Security Grade (SG) 2
Environmental Class (EC) II
E N G L I S H
Installation Notes
It is recommended the contact is registered at the control panel. A signal strength test
should then be performed to make sure the most suitable location is chosen,ensuring
optimum wireless range.
Installation Surfaces
The contact can be mounted on typical building materials; such as wood, PVC,
brick or metal etc.
Programming Menus Required
1 WIRELESS DEVICE CONTROL
2
A REGISTER WIRELESS DEVICE
Register Locally
1. Make the security control panel enter the registration mode.
2. Register the detector: Hold the registration key until the three LEDs flash alternately.
The green LED will flash 8 times if the registration is finished.
3. Communication Test: Release the TAMPER spring to trigger the alarm.
Note: The distance between the security control panel and the detector should be less
than 50 cm.
Initialize the Detector
1. Remove the battery to power the detector off.
2. 5s later, hold the registration key and reinstall the battery to power the detector on
at the same time to make the three LEDs start flashing alternately. Release the
registration key while the three LEDs flash once together.
A
3
DIAGNOSTICS
Specification
Battery:
Type: 3.0V CR123A.
Threshold: 2.5V +/- 5% at 25°C.
Life: Up to 2 years
Wireless:
Transmission Frequency: 868MHz FM transceiver narrow band Transmission
Method: Fully encrypted rolling code
Materials and Environment
Colour and Casing: White. 2mm ABS
Indication: LEDs (Signal, Battery, Alarm, Tamper)
Temperature: -10℃ to 40℃ (Certified)
Dimensions (H x W x D): 27 x 104 x 25mm. Magnet: 14 x 49 x 16mm
Magnet Detection Performance
Without Nominal Distance With Nominal Distance (5mm)
Axes of Event Distance in Distance in Distance in Distance in
Operation Air Iron Air Iron
Z+ Remove 35mm 24mm 32mm 20mm
Approach 33mm 20mm 30mm 18mm
Z- Remove 35mm 22mm 32mm 20mm
Approach 33mm 20mm 30mm 18mm
Y Remove 24mm 12mm 20mm 7mm
Approach 22mm 10mm 18mm 5mm
X+ Remove 14mm 13mm 16mm 10mm
Approach 13mm 12mm 15mm 9mm
X- Remove 14mm 12mm 14mm 12mm
Approach 13mm 11mm 13mm 11mm
Battery Information
The batteries supplied have been chosen to privide long service life whilst, for
safety reasons, having limited output current.
The batteries is protected on purchase by a piece of plastic that must be
removed for operation. When disposing of the product, the battery must be
removed and disposed of separately in accordance with the local regulations.
1
3
Hangzhou Hikvision Digital Technology CO.,Ltd.
2
300s
No. 6.
Pan Head
Screw
10m
No.555 Qianmo Road, Binjiang District, Hangzhou 310052, China
>5s
REGISTRATION
5s
LEDs
LEDs
This product and - if applicable -
the supplied accessories too are
>10m
marked with "CE" and comply
therefore with the applicable
harmonized European standards
listed under the RE Derective
2014/53/EU,the RoHS Directive
2011/65/EU.
For electrical products sold within
the European Community. At the
end of the electrical products life,
it should not be disposed of with
household waste. Please recycle
where facilities exist. Check with
your local Authority or retailer for
recycling advice in your country.