Nilfisk UZ 964 Ergoclean Instrucciones De Uso página 8

PLEASE READ THESE ESSENTIAL INSTRUCTIONS
UZ 964 are designed, developed and rigorously tested to
function efficiently and safely when properly maintained and
used in accordance with the following instructions. These
instructions have been prepared with safety and efficiency
paramount.
The MACHINE OPERATOR must be trained by a suitably
qualified instructor, and be made aware of the relevant
regulations and legislation currently in force at the time of
use.
CAUTION - This machine MUST NOT be used in explosive
or inflammable atmospheres or where such atmospheres
are likely to be produced by the presence of volatile liquid or
inflammable gas or vapour.
CAUTION - In no circumstances should the power supply
cord be wrapped around fingers or any part of the operators
person.
CAUTION - The electrical supply plug must not be subjected
to undue stress by pulling on the power supply cord.
Your MACHINE must only be connected to an electrical
supply of the same voltage and frequency as indicated on the
rating plate. Ensure that the plug fitted to the end of the power
supply cord is suitable for your supply socket, if not refer to
the information contained in 'Electrical Connections', or
consult a qualified electrician. The electrical installation from
which the supply is drawn must be maintained to current
Institute of Electrical Engineers wiring regulations.
8
(Only applicable to UK)
REGULAR SERVICING and INSPECTION of your machine
must be carried out by suitably qualified personnel in
accordance with relevant legislation and regulations. In
particular, electrical tests for earth continuity, insulation
resistance, and condition of the flexible cord should be
checked frequently. In the event of any defect the machine
MUST be withdrawn from service, completely checked and
repaired.
Trained Service Engineers will be pleased to carry out on site
servicing on a regular or as requested basis, to ensure the
continuing safety and efficiency of your machine.