DeWalt DWE1622 Manual De Instrucciones página 25

Fitting the Lubrication System (Fig. D)

WARNING: Do not use the lubrication system in
vertical or overhead drilling applications.
The lubrication system can be used for horizontal drilling
applications (the drill being used vertically).
1. With the coolant bottle 10
bracket 5 , slide the magnetic bracket onto the either
side of the steel strip 20
2. Attach the coolant tube
11
a. Remove the nut and thread it onto the tube
21
b. Slide the tube onto the nipple and tighten the
nut 21 .
3. Attach the tube to the quick-release connector
the gearbox.
a. Push the coolant tube
b. To remove, push the collar on the connector
and pull the tube from the connector.
In order to use the lubrication system, the coolant bottle
must be filled with a sufficient amount of cutting fluid.
Fig. D
12
21
11
d
r lo a
o v e
Filling the Coolant Bottle
1. Make sure the flow regulator
2. Unscrew the cap 22 .
3. Fill the container with cutting coolant diluted
with water.
4. Screw the cap back on.
Fitting the Safety Chain (Fig. E)

WARNING: Always use the safety chain.
Thread the provided safety chain
unit and around the workpiece and secure in place.
placed into the magnetic
.
to the coolant bottle:
11
12 on
11 in to install.
in
12
10
20
22
10
5
11
13
13 is closed.
15 through the handle of
Fig. E
15
.
Inserting and Removing an Accessory
(Fig. F)
The tool holder accepts annular cutters with a 19 mm shank
with two flats.

WARNING: The teeth of a cutter are very sharp and
can be dangerous.
1. Slide the pilot pin through the hole in the center of the
cutter shank.
2. Push up on the quick-release collar
3. Insert the cutter 24
meets the locking pin. When the flat meets the locking
pin the collar will snap down.
4. Check that the cutter is securely held in the arbor.
5. Lift the collar to release the cutter.
Fig. F
23
3-Jaw Chuck (Fig. G)
A D WALT 3-jaw chuck
e
adaptor 26 to fit the drill press for various bit sizes. Refer
to Inserting and Removing an Accessory for installation
instructions.
NoTE: It may be necessary to adjust the motor position
when chuck is installed. Please refer to Adjusting the Motor
Height for instructions.
Consult your dealer for further information on the
appropriate accessories.
ENGlIsh
23 .
with pilot pin and turn until the flat
2
1
24
can be installed using an
25
23