Operating Hoverpod - WowWee FlyTech HOVERPOD Guia De Inicio Rapido

enGlisH

operating Hoverpod

When Hoverpod is fully charged it is ready for use . You can use it on smooth carpet or
smooth surfaces . You should avoid using it on elevated surfaces such as table tops .
IMPORTANT: Do not use Hoverpod outdoors, near water or on long pile carpet .
IR Band
Hoverpod is available in two infrared (IR) bands, enabling you to race two
Hoverpods of differing IR bands, each with independent control . Before you
use Hoverpod, set the remote controller to the correct band using the IR
band selector .
If your Hoverpod is blue, select A . If your Hoverpod is silver, select B .
You can also check the packaging to see what band your Hoverpod is .
Operating Hoverpod
To operate Hoverpod do the following:
1 . Turn the remote controller on by setting the power switch to ON .
The LED indicators will light up and remain lit .
2 . Turn Hoverpod on by setting the power switch to ON .
The LED signal indicator will light up .
3 . Place Hoverpod on a suitable surface . Push the throttle to control the power
and speed of Hoverpod; push the direction toggle left or right depending
on which way you want to turn .
NOTE: Always point the remote controller directly at Hoverpod .
6