Charging Hoverpod - WowWee FlyTech HOVERPOD Guia De Inicio Rapido

Charging Hoverpod

Before using Hoverpod for the first time, or if you have depleted the charge, you will
need to recharge it . This usually takes about 10 minutes and gives up to 5 minutes
of play . If the charge time begins to exceed 15 minutes, replace all of the batteries
in the remote controller with fresh batteries .
To charge Hoverpod, do the following:
NOTE: Verify that Hoverpod is turned OFF before you charge it .
1 . Pull out the charger cable located on the bottom side of the remote controller .
2 . Insert the charger cable into the socket on
Hoverpod, as illustrated .
3 . Slide the power switch on the remote
controller to CHG . If the connector on the cable is properly connected to
the socket, the LED indicators on the remote controller will pulse slowly to
indicate it is charging properly .
4 . When Hoverpod is fully charged, the LED indicators will blink
twice and then pause before blinking again .
enGlisH
5