Protect from frost
Your pump is susceptible to low temperatures. Make sure to empty the pump of residual liquid
and store it so that it is protected from frost.
Disposal
The device must not be included in household waste, but rather, it must be disposed
of professionally. The appliance, its packaging and accessories are all produced from
recyclable materials and must be disposed of accordingly
Malfunctions
Before you attempt to remedy any malfunction of your pump, pull the plug to prevent injury
!
or death due to electrocution!
What is wrong?
Motor does not run.
Submersible pump runs but
is not pumping out liquid.
Submersible pump is only
pumping
out
liquid
slowly or weakly.
If you are unable to remedy a malfunction, please call the AL-KO service centre nearest you.
Translation of original user instructions
What is the possible reason?
Impeller is blocked.
Thermal switch has switched off.
No power.
Float switch does not work even
though liquid is above cut-in level.
Air is trapped in the pump hous-
ing.
Suction slots are blocked.
Pressure line is blocked.
Pressure hose is bent.
Pressure blockage
Hose diameter is too small.
very
Suction slots are blocked.
Pumping height is too great.
.
How to remedy the malfunction:
Remove blockage in inlet area.
Clean the impeller with a jet of
water.
Wait until the thermal switch has
automatically turned the pump on
again. Check water temperature.
Have the pump checked.
Have a qualified electrician check
the power supply.
Send
pump
to
your
AL-KO service centre.
Tilt the pump to let the trapped air
out.
Wait for a maximum of 3 minutes
until the air cushion has escaped
from the pump space.
In flat suction operation, switch on
an off briefly several times, if
necessary.
Remove
blockage
suction slots.
Clear blockage in pressure line.
Straighten out pressure hose.
Clear blockage
Attach a hose with a larger diame-
ter.
Remove
blockage
suction slots.
Lower pumping height.
nearest
and
clean
and
clean
GB 4