Preparing Evolution 5000 For Video Transmission; Operating The System; Maintenance; Cleaning - MSA EVOLUTION 4000 Manual Del Usuario

3.3 Preparing EVOLUTION 5000
for video transmission
Switch on the camera or transmitter in accordance with the
operating instructions.
The channel selected on the camera must correspond to the
receiver unit channel.
Radio transmission takes place via channel 1 if one LED on the
transmitter lights. A change to channel 2 can be made by briefly
pressing the button - 2 LEDs light.
4

Operating the system

Optimal radio transmission and thus maximum range is only
guaranteed if the receiver antenna is directed towards the ther-
mal imaging camera with the transmitter.
The range (see technical data) of the radio transmission is
dependent upon ambient conditions. Shielding materials such
as walls and reinforced concrete, metal constructions or even
high air humidity can cause disturbances and therefore affect
the range of a perfect radio transmission.
Should the transmission on one channel be disturbed then a
changeover can be made to the other channel on the camera
and receiver unit.
12
5

Maintenance

General Maintenance
The following is to be checked after each use:
●
Visual check of all parts for mechanical, chemical or heat-
related damage.
●
Visual check of the components for loose and/or missing
screws, as well as loose and/or missing O-rings and/or
seals.
●
For batteries see manual of the camera / video transmitter
Note:
Components that do not pass visual inspection must be
taken out of operation until the appropriate repairs have been
done. Repairs or changes that are outside the measures
described in these instructions or in the instructions for use of
the camera / video transmitter or that are carried out by anyone
other than a person authorised by MSA AUER lead to the inval-
idation of any warranty claim. Use only original MSA AUER
replacement parts.
6

Cleaning

After each use all external surfaces are to be wiped with a solu-
tion of mild cleaning agent and warm water. Then rub dry with
a soft, dust- and lint-free cloth, during which care is to be taken
that optical components are not scratched.
Check connections, sockets, switches, locks and hinges for
fouling and if necessary clean with a soft, dust- and lint-free
cloth.
7

Technical data

7.1 Transmitter
(transmitter on/in the camera)
Frequency:
Country-specific frequencies are pre-set. No setting of other
frequencies by the user is permitted.
Transmission power EIRP:
GB
2.3 - 2.4 GHz
450 mW
GB