Positioning The Spotlight; Solar Panel; Charging The Rechargeable; Battery - LIVARNO home 1020-B Instrucciones De Uso

Screw the Spotlight star knob
„
screw and tighten it hand-tight. Check that
the product is fixed firmly in place.
z Positioning the Spotlight/

solar panel

Positioning model 1020-B
The Spotlight can be adjusted horizontally
(top/bottom) to an angle of up to 180° (see
Fig. D).
Loosen the two Spotlight star knobs
„
adjust the Spotlight (see Fig. B).
When the desired position is obtained,
„
tighten the star knobs again. If necessary,
use a screwdriver to hold the screw while
tightening the star knob.
Positioning model 1020-S
The Spotlight can be adjusted horizontally
(top/bottom) to an angle of up to 180° (see
Fig. H).
Loosen the wall bracket star knob
„
adjust the height of the Spotlight (see Fig.
H).
When the desired position is obtained,
„
tighten the star knob again.
Loosen the two Spotlight star knobs
„
adjust the angle (see Fig. H).
When the desired position is obtained,
„
tighten the star knob again. If necessary,
use a screwdriver to hold the screw while
tightening the star knob.
Note: the motion sensor has a field of view
of up to 120°. Make sure that the motion
sensor faces directly towards the desired
detection zone.
Note: to ensure the solar panel functions as
effectively as possible, make sure that the
surface of the solar panel
Orientation:
The optimum alignment is facing south.
Choose an orientation facing slightly to the
west rather than slightly to the east.
10
US-EN
onto the
6
to
6
to
10
to
9
is not dirty.
2
z Charging the rechargeable

battery

The battery is charged in all operating
„
modes. To optimize initial charging, charge
the product while it is turned off.
Note: the battery is fully charged after it has
been well exposed to sunlight for 7 to 8
hours. The duration of the charging process
depends on the battery's charge level and
the quality of the sunlight.
z Operation
The product can be operated in three
different modes. The operating mode is set
by means of the switch
Note: the solar panel will turn on the
product in twilight or darkness in the mode
you have set.
Note: battery charging via the solar panel
does not depend on which mode is selected.
The battery is charged continuously at all
times.
Mode 1
Press and hold the switch
„
to switch to "Mode 1".
The Spotlight will light up once and then
„
switch to guide-light function (reduced
brightness).
If the motion sensor detects movement
„
within its range, the Spotlight will light up
at maximum brightness.
After approx. 15 seconds, it switches back
„
to guide-light function.
Mode 2
Press the switch
„ 5
"Mode 2".
The light will flicker twice and then switch off.
„
If the motion sensor detects movement
„
within its range, the Spotlight will light up
at maximum brightness.
After approx. 15 seconds, it will switch off
„
again�
�
5
for 3 seconds
5
again to switch to