Alarm Unsetting; Partial Alarm Setting - jablotron JA-103K Manual Del Usuario

2.1.3.2. ALARM UNSETTING

1. When you enter the
building
(triggering a detector with a "Delayed
zone" reaction), the system starts
indicating an entrance delay with a
continuous tone, the system indicator
and a function button, both fl ashing
red, of the section in which the de-
layed entrance has been triggered.
Note: If the "Unset section by authorization only during entrance delay" parameter is enabled, then mere
authorization will unset a section where the entrance delayed has been triggered. This option should be
used with caution when using multiple sections.
Consult the installation with a service technician in order to program the desired behavior of the system.

2.1.3.3. PARTIAL ALARM SETTING

WARNING: This is an additional function of the alarm system.
The system can also be confi gured to be partially set which allows guarding only by certain detectors in a
section.
Example: At night, it is possible to set the door and window detectors only, while selected motion de-
tectors will not trigger the alarm when somebody moves inside the section.
1. Authorize yourself using
the keypad (enter a code or hold an
RFID card or tag up to the reader).
The system indicator button will start
fl ashing green.
36
2. Authorize yourself using
the keypad – the system indicator will
start fl ashing green.
3. Press the function buttons
of the sections you want to unset.
2. Press the function
button
of the selected section.
4. The command
is executed
The function buttons and the system
indicator turn green to indicate unset
sections.
3. The command
is executed
and the function button turns per-
manently yellow to indicate a partially
set section.