Technical Support - Kensington SlimBlade Manual De Instrucciones

Presenter Mode
To use in Presenter Mode to control a slide presentation, keep switch in up position,
indicated by presentation screen .
Starts presentation
Previous slide
Blank screen/Resume screen
To activate the laser pointer, press .
Common Troubleshooting Steps
1. Un-plug and re-plug the receiver.
2. Install fresh batteries in the mouse
3. Test the device on another port or computer.
4. Some surfaces may "trick" the sensor, such as reflective surfaces like glass or mirrors.
As a result this product will not work well on glass or mirror surfaces. The sensor
should perform well on all other surfaces.
Laser pointer
Next slide
Presenter Mode
8
IMPORTANT: Computer User Health Information
In recent years, medical attention on occupational injuries has identified normal,
seemingly harmless activities as a potential cause of a wide range of problems collectively
known as Repetitive Stress Injuries (RSI) or Cumulative Trauma Disorders (CTD). It is now
recognized that any repetitive motion may contribute to these health problems. As a
computer user, you might also be at risk.
By paying attention to the way you perform your work, use your computer and phone,
play sports, and work around the house, you can identify the behaviors that may
be putting you at risk. If you experience pain, swelling, numbness, or weakness in
your wrists or hands (especially during sleep), see your physician immediately. These
symptoms could mean that you are developing a repetitive stress injury that requires
prompt medical attention. For more detailed information, consult your doctor.

Technical Support

Technical support is available to all registered users of Kensington products. There is no
charge for technical support except the cost of the phone call, and long distance charges
where applicable. Technical Support Contact information can be found on the back page
of this manual.
Technical Support Tips
• You may find the answer to your problem in the Frequently Asked Questions (FAQ) section
of the Support area on the Kensington Website: www.support.kensington.com.
• Call from a phone where you have access to your computer
• Be prepared to provide the following information:
- Name, address, and telephone number
- The name of the Kensington product
- Make and model of your computer
- Your system software and version
- Symptoms of the problem and what led to them
CLASS 1 AND CLASS 2 LASER SAFETY STATEMENT:
This device complies with international standard IEC 60825-1: 2001-08, class 1 and class 2 laser products and also
Comply with 21 CFR 1040.10 and 1040.11 except for deviation pursuant to Laser Notice No. 50 dated 7/2001.
Operating temperate: between 0 ° C (32° F) to 40° C (104° F).
CAUTION: This device has no serviceable parts. Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiation exposure.
CLASS 1 LASER DEVICES (INVISIBLE LASER)
1. Emission of a parallel beam of infrared user-invisible light, which is safe under reasonably
foreseeable conditions of operation
2. Maximum power of 716 microwatts CW, wavelength range 832-865 nanometers
3. Class 1 laser beam is emitted from the bottom of the device
4. CAUTION: While the Class 1 laser in this product is safe under normal use, the laser beam
(which is invisible to the human eye) should not be pointed at anyone's eyes.
CLASS 2 LASER DEVICES
1. Emission of a parallel beam of visible light
2. Maximum Power of 1 milliwatt CW, wavelength range 650±20 nanometers
3. Class 2 laser beam is emitted from the front of the device
4. Class 2 laser Safety Caution:
9