Cembre B1300PL Manual De Uso página 7

2. INSTRUCTIONS FOR USE
The part reference includes the following:
Hydraulic battery pump.
Flexible hose 900 mm (35.4 inch).
Li-Ion rechargeable battery (1 pc).
Battery charger (model depends on the pump version).
Shoulder strap.
Plastic carrying case.
USB cable (See page 31).
2.1) Preparation
The pump can be easily carried using either the main handle (10) or the shoulder strap attached
to the two rings (7) (Ref. to Fig. 4).
The main operating positions are: horizontal standing on its feet and vertical standing on its bat-
tery. In addition to the main handle (10) the lower handle (6) allows a safer and more balanced grip
when using two hands to hold the pump (Ref. to Fig. 2).
Before starting any work, check the battery charge (Ref. to § 2.5) and recharge if necessary,
following the instructions in the battery charger user manual.
To replace the battery, grip the pump as illustrated in Figure 1; press the release button (9) and
push the battery downward to unlock it.
Insert a charged battery from the bottom by sliding it into the guides until it locks.
Connect the fl exible hose to the female coupler (4) on the pump, and to the male coupler on the
hydraulic head (see Fig. 3).
IMPORTANT: Never connect to a pump hydraulic heads that still contains oil, namely with
the ram not fully retracted; excess oil could cause the pump to malfunction.
2.2) Operation
Press operating button (1) to activate the motor and pump oil to
the hydraulic head.
When the operating pressure is achieved, the pump stops automati-
cally and oil pressure is maintained.
If the operating button (1) is released before the motor stops au-
tomatically, the pump maintains the oil pressure at the achieved
level. To complete the operating cycle, press and hold the opera-
ting button.
When a crimping head is used, press and hold the operating button (1) until the motor
stops automatically.
7
1