Remote Controller; How To Insert Batteries - Quasar HQ-2052UH Instrucciones De Instalación Y Operación

Remote controller

Precaution:
The Remote Controller will not function properly if strong light strikes the sensor window of the
air conditioner or if there are obstacles between the Remote Controller and the air conditioner.
OPERATION BUTTON
• To turn the air conditioner ON, push the button. To turn the air conditioner OFF, push the button again.
• This button takes priority over any other buttons.
• When you first turn it on, the air conditioner is on the High cool mode and the temp. at 72°F (22°C).
ROOM TEMPERATURE SETTING BUTTON
This button can automatically control the temperature of the room. The temperature
can be set within a range of 60°F to 86°F by 1°F. (16°C to 30°C by 1°C)
Select the lower number for lower temperature of the room.
ON/OFF TIMER BUTTON
• You can set the time when the unit will turn on or turn off automatically by pressing the timer
button. If the unit is in operation, this button controls the time it will be turned off. If the unit is
in off state, this button controls the time it will start. Every time you push this button, the
remaining time will be set as follows:
- STOPPING OPERATION
• Every time you push this button, when the air conditioner is operating, timer is set as
follows : (1Hour 2Hours
8Hours 9Hours 10Hours
• The Setting Temperature will be raised by 2°F (1°C) 30 min. later and by 2°F (1°C) after
another 30 min.
- STARTING OPERATION
• Every time you push this button, when the air conditioner is not operating, timer is set as
follows : (1Hour 2Hours
8Hours 9Hours 10Hours
OPERATION MODE SELECTION BUTTON
Every time you push this button, it will toggle between COOL, ECONOMY, FAN
and DRY.
ECONOMY
• If you push this button, the fan stops when the compressor stops
cooling. Approximately every 3 minutes the fan will turn on and check
the room air to determine if cooling is needed.
FAN SPEED SELECTION BUTTONS
Every time you push this button, it is set as follows.
{High(F2) Low(F1)

How to Insert Batteries

1.
Remove the cover from the back of the remote
controller
2.
Insert two batteries.
• Be sure that the (+) and (-) directions are correct.
• Be sure that both batteries are new.
3.
Re-attach the cover.
3Hours 4Hours 5Hours
11Hours 12Hours 0Hour
3Hours 4Hours 5Hours
11Hours 12Hours 0Hour
High(F2)...}.
6Hours 7Hours
1Hour 2Hours ...)
6Hours 7Hours
1Hour 2Hours ...)
6
OPERATION
TEMP
TIMER
MODE FAN SPEED
ECONOMY
• Do not use rechargeable
batteries. Such batteries
differ from standard dry
cells in shape, dimensions,
and performance.
• Remove the batteries from
the remote controller if the
air conditioner is not going
to be used for an extended
length of time.