Care & Cleaning - Uline Foodsaver Guia Del Usuario

OPERATING ISSUE
Appliance does not function, or Stop/Seal
Button (C) flashes to signal error.
FOODSAVER VACUUM SEALING ACCESSORIES
®
Accessory Hose Reel
1. Prepare container according to FoodSaver
Accessory Guidelines.
2. Pull Accessory Hose (F) from appliance and Insert
the end into the port on accessory. Twist tab while
inserting to ensure a tight fit.
TO CLEAN APPLIANCE:
Open appliance door (D). While holding the appliance
with two hands, press two Green Release Buttons (I) with
your thumbs, rotate appliance away from you and
allow appliance to rest on the counter. After cleaning,
hold appliance with two hands and rotate upright until
the latches lock.
For important product maintenance information and
helpful tips, please refer to the FoodSaver
Guide included in your kit.
PAGE 5 OF 15
TROUBLESHOOTING
RECOMMENDATIONS
• Check power cord to see if it is firmly plugged into an electrical outlet.
• Examine power cord for any damages.
• See if electrical outlet is working by plugging in another appliance.
• Check to be certain the Upper Bag Detection Tray (L) is
properly inserted.
• Make sure bag is placed correctly inside Vacuum Channel (E).
• Check to ensure Green Release Buttons (I) are properly latched.
• Check Gasket (J) around Drip Tray to make sure it is free from food
material and Upper Foam Gasket (M) is properly inserted into gasket
channel.
• If overheated, allow appliance to cool for 20 minutes.
ACCESSORIES
3. Push Accessory Vacuum Button to begin vacuum
®
4. To retract accessory hose, gently pull on hose end
CARE & CLEANING
Reference
®
1-800-295-5510
uline.com
process. Motor will run until vacuum process is
complete.
while holding unit, and allow hose to retract into
appliance housing. Do not release freely as it may
damage the hose tip.
IMPORTANT! When pulling hose out, do not
extend beyond green circle marked on hose.
NOTE: Empty Drip Tray after each use. (See
Figure 9) Wash in warm soapy water or place in
top rack of dishwasher. The Food Sensors in the
Drip Tray (K) will not function correctly if liquid is
allowed to remain in Drip Tray.
Remove For Cleaning
Figure 9
0621 IH-3404