Axxess AXSWCH-FD1 Manual De Instrucciones

Ford Transit (with 4.2-inch display screen) 2015-2019
• Pre-wired AXSWC harness (AXSWC sold separately) • Retains the factory backup camera
CAUTION!
All accessories, switches, climate controls panels, and especially air bag indicator lights
must be connected before cycling the ignition. Also, do not remove the factory radio with the key in the
on position, or while the vehicle is running.
To retain the factory backup camera:
• Connect the Yellow RCA jack to the backup camera input of the aftermarket radio.
12-pin pre-wired AXSWC harness:
• This harness is to be used along with the optional AXSWC (not included) to retain steering
wheel audio controls. If the AXSWC is not being used, disregard this harness. If it will be
used, please refer to the AXSWC instructions for radio connections and programming .
Note: Disregard the harness that comes with the AXSWC.
• Connect the Black wire to chassis ground.
• Connect the Red wire to accessory power.
• With all connections complete, connect the AXSWCH-FD1 harness to the wiring harness
disconnected from the factory display screen.
INTERFACE FEATURES
INTERFACE COMPONENTS
• AXSWCH-FD1 harness
• Cutting tool • Tape • Crimping tool
• Connectors (example: butt connectors, bell caps, etc.)
Connections to be made
Integrate • AxxessInterfaces.com
© COPYRIGHT 2019 METRA ELECTRONICS CORPORATION
AXSWCH-FD1
INSTALLATION INSTRUCTIONS
TOOLS REQUIRED
REV. 12/11/19