Technoline WL 1040 Manual De Instrucciones página 16

4) Repeat 2) to set high alert level of RH% (default at 70%). The highest
RH% alert level is 95%.
5) Press
Note:
•
Your monitor will store your settings and exit the alert set mode when
no key is pressed in approximate 10 seconds.
•
When the measured CO
the related
flashes to remind you.
To use the acoustic CO
•
Press and hold the
When the alarm is on, the
•
When the measured CO
digits, the
given continuously. The beep sound will accelerate when the
measured CO
If this happens, please open the windows, adjust the air ventilation and
avoid too many people gathering together to improve the air quality of
your environment.
•
Press any button to stop the sound temporarily (it will sound again in
15 seconds). To completely disable the CO
hold the
icon remain flashing if CO
to confirm and end the setting.
2
or icon appears and flashes The CO
Alarm (for high alert)
2
button to turn on the CO
2
and icons flash and an acoustic beep sound will be
level exceed more over the set high alert level.
2
button until the
or RH% reaches the set high / low alert level,
icon appears on the display.
reaches the set high alert level, both the CO
icon disappears. The CO2 digits and
exceeds the set high alert.
2
EN5
reading also
2
acoustic alarm.
2
voice alarm, press and
2
2