mm/dd/yy hh:mm:ss
mm/dd/yy hh:mm:ss sets the date and time. Some error messages can display the date and time of
occurrence, see Section 7.
ANALOG COMM - ACOM
RESISTIVITY
DRAINING
RESTORE DEFAULTS
mm/dd/yy
Show Quick Start
Show Quick Start
Show Quick Start reruns the initial start up menu. The Quick Start menu will appear the next time
the chiller is started.
ANALOG COMM - ACOM
RESISTIVITY
DRAINING
RESTORE DEFAULTS
mm/dd/yy
Show Quick Start
DRAINING (Optional)
DRAINING opens/closes the optional anti drainback valve. The chiller must be off to drain the valve.
Press enter to start the draining. The display will change to Close Valve. When the draining is com-
plete press enter again to close the valve.
DRAINING
Open Valve
Thermo Scientific
Press the arrows to highlight the desired setting. Press
enter to start the highlight flashing. Press the arrows
to change the setting. Press enter to accept the change
and stop the flashing.
hh:mm:ss
With Show Quick Start highlighted press enter.
The Quick Start menu will appear the next time the
chiller is started.
Note If Show Quick Start is enabled and power
is lost, if auto restart was enabled the chiller will not
hh:mm:ss
automatically restart once power is restored. In this
case only the controller is powered.
DRAINING
Close Valve
Section 4
ThermoFlex 4-21