Uline H-5532 Guia De Inicio Rapido página 3

Figure 1
2
4
Figure 2
Figure 3
PAGE 3 OF 12
ASSEMBLY INSTRUCTIONS
5
2
1
4
4
6
ASSEMBLING MAIN PANELS
NOTE: Do not tighten bolts until unit is
completely assembled.
1. Locate and separate the left and right-hand sides
(2 & 6). Identify the top of each panel. The top of
each panel has three holes instead of one.
2. Place back (1) on a protected flat surface so that
the flanges face upward.
3. Bolt left side (2) to the back (1) so that side flange
fits around back (using 7 bolts and nuts—nuts to the
inside) Do not use bottom two holes; these will be
used for attaching legs in step 7. (See Figure 1)
4. Next bolt top (4), bottom (4) and intermediate top
(4) to back and left side panel using 4 bolts and
nuts each. (See Figure 2)
5. Attach coat hooks (5) to the left side and back
panels:
• Sides – 2nd, 3rd & 9th, 10th holes from top.
• Back – 2nd, 3rd & 11th, 12th holes from top.
6. Bolt right side (6) to the back so that side flange
fits around back. Attach side to top, bottom and
intermediate top. Attach remaining coat hook to
the right side panel. (See Figure 3)
0821 IH-1224