Driving Mechanism - BERG XL FRAME Manual De Usuario

1
BERG Large Ride-ons
2.2.4 Steering
The steering equipment must be checked every month for the following:
• Damage and/or wear and tear to steering equipment.
• All the nuts and bolts must be tightened.
4
a
Check alignment of the smallest deflection of the left and the right wheel with the
front bumper 1a and 1b. Loose the steering swivel at the side of the wheel with the smallest deflection.
A
Than push the wheel away from the bumper. After that tighten the steering swivel well.
B
1
4
b
1a 1b

2.2.5 Driving mechanism

2.2.5.1 Chain
The product has a driving mechanism with two chains. Make sure that the chains are sufficiently oiled
so that they can travel freely. If a chain is too tightly tensioned, the gokart will be more difficult to pedal
and there is a big chance that wear and tear of the chains and sprocket, among other things, will occur
faster. If a chain is not tight enough, then the chain can easily come off the sprocket, or there is a chance
7
of damage to the chain housing. When both chains must be tensioned, always begin with the rear/short
chain.
Tensioning the front chain:
• Loosen the bolts on the underside of the frame.
• Tension the chain by moving the crank axle forwards.
• Tighten the bolts again.
• It must be possible to push the middle of the chain downwards by 10 millimeters. To check this you
must remove the lower half of the chain housing.
1
21
2
5
a
A
B
2
B
5
b
1
2
8
2
1
A
1
2
2
3
6
a
A
3
6
b
X=Y / X=Y-5mm
9
3