Installation; Unpacking And Levelling; Electric And Water Connections - Hotpoint Ariston ARTXF 129 Manual De Instrucciones

Installation

!
Keep this instruction manual in a safe place for
GB
future reference. Should the appliance be sold,
transferred or moved, make sure the instruction
manual accompanies the washing machine to inform
the new owner as to its operation and features.
!
Read these instructions carefully: they contain vital
information on installation, use and safety.

Unpacking and levelling

Unpacking
4. Seal the gaps using the plastic plugs provided.
5. Keep all the parts: you will need them again if
the washing machine needs to be moved to
another location.
Warning: Warning:
Warning: Warning: should the screws be re-used, make sure Warning:
you fasten the shorter ones at the top.
!
Packaging materials are not children' s toys.
Levelling
Your machine may make a considerable amount of
noise if the two front feet have not been adjusted
correctly.
the adjustable front feet (see figure); the angle of
inclination, measured according to the worktop,
must not exceed 2°.
2
1. Unpack the
washing machine.
2. Check whether the
washing machine has
been damaged during
transport. If this is the
case, do not install it
and contact your
retailer.
3. Remove the four
protective screws and
the rubber washer
with the respective
spacer, situated on
the rear of the
appliance (see figure).
1. Install the washing
machine on a flat
sturdy floor, without
resting it up against
walls, furniture cabinets
or other.
2. If the floor is not
perfectly level, com-
pensate for any
unevenness by
tightening or loosening
Levelling your appliance correctly will provide it with
stability and avoid any vibrations, noise and shifting
during operation. If it is placed on a fitted or loose
carpet, adjust the feet in such a way as to allow
enough room for ventilation beneath the washing
machine.
Putting your appliance in place and moving it.
appliance is in the required position, put the lever
back in place. The washing machine is now firmly in
place (see figure).

Electric and water connections

Connecting the water inlet hose
A
3. Make sure there are no kinks or bends in the hose.
!
The water pressure at the tap must be within the
values indicated in the Technical details table
(on the next page).
!
If the water inlet hose is not long enough, contact
a specialist store or an authorised serviceman.
If your washing
machine is equipped
with a special set of
retractable wheels you
can easy move it. To
lower the wheels and
thus move the
appliance effortlessly,
just pull the lever,
situated on the left-
hand side beneath the
base. Once the
1. Insert seal A into the
end of the inlet hose and
screw the latter onto a
cold water tap with a 3/4
gas threaded mouth (see
figure).
Before making the
connection, allow the
water to run freely until it
is perfectly clear.
2. Connect the other
end of the water inlet
hose to the washing
machine, screwing it
onto the appliance' s
cold water inlet, situated
on the top right-hand
side on the rear of the
appliance (see figure).