YATO YT-82380 Manual De Instrucciones página 17

GB
counter-clockwise for external cutting and clockwise for internal cutting. This prevents the cutter from jumping and ensures a good
cutting result.
The speed of the plunge router should be adjusted experimentally, it is recommended to carry out tests using waste made of the
same material as the intended workpiece. The slower the speed, the better the cutting result. However, too slow a speed may
cause the surface being cut to burn and leave permanent marks on it.
Cutting parallel to the edge (XVII)
In the case of such cutting, one of the edges of the workpiece shall be treated as the reference line for the routing of the plunge
router. Set the cutting depth, set the guide for parallel cutting in the desired position, rest the guide plate against the edge of the
workpiece and then move the plunge router so that the retaining plate always rests on the edge along its entire length. The cutter
track will be parallel to the edge
Circular cutting (XVIII)
In this cutting process, the pivot point is used as the centre of the circle which determines the cutter track. Set the cutting depth,
set the guide for circular cutting in the desired position and set the guide needle to the point which will be the centre of the circle.
If possible, make a small indentation so that the needle blade has a better support. Then move the plunge router around a circle
whose radius will be the distance between the axis of the needle and the axis of the cutter.
Tips for cutting
During cutting, the plunge router should be guided by a smooth motion at a uniform speed. The smoother the guiding motion, the
higher the cutting quality.
Avoid hitting the workpiece with the cutter.
Allow the plunge router to reach the set speed and only then start cutting.
If cutting must be continued, enter the cutter into the track at full speed. This will prevent the cutter from being jammed in the
workpiece.
MAINTENANCE AND OVERHAUL
CAUTION! Before carrying out any adjustment, servicing or maintenance work, unplug the tool from the power outlet. Having
fi nished working with the workpiece/material, inspect the power tool for damage by visually inspecting the exterior and the body
and the handles. Check the power cord and its rubber gland, the action of the ON/OFF switch, the vents for clogging, the motor
brushes for sparking, the noise of the bearings and the drive transmission, and how the power tool starts and runs. During the
warranty period, the user is not allowed to disassemble the tool or replace any components or parts, as this will void the warranty
rights. Any irregularities found during overhaul or the operation signal the need for repair at a service centre. For this purpose,
contact the manufacturer. Having fi nished your work, clean the housing, the vents, all switches, all handles and guards with
compressed air (at 0.3 MPa maximum), a brush or a dry cloth. Do not use any chemicals or cleaners. Do not use sharp tools for
cleaning. Remove the circular saw and clean the inside of the guards, the fi xing of the circular saw, as well as the saw itself from
dust and other impurities generated during operation. Clean handles, knobs and other adjusting parts with a dry, clean cloth.
O R I G I N A L I N S T R U C T I O N S
17