Safety Warnings - STEINEL HL 1821 S Manual Del Usuario

GB Translation of the original
operating instructions
Please familiarise yourself with these operating instructions
before using this product because prolonged reliable and
trouble-free operation will only be ensured if it is handled
properly.
We hope your new hot air tool will give you lasting
satisfaction.

Safety warnings

Read and observe this information
before using the tool. Failure to
observe the operating instructions
may result in the tool becoming a
source of danger.
When using electric power tools,
observe the following basic safety
precautions to avoid electric shock
as well as the risk of injury and fire.
Used carelessly, the tool can start an
unintentional fire or injure persons.
Check the tool for any damage
(mains connection lead, housing etc.)
before putting it into operation and
do not use the tool if it is damaged.
Do not leave the tool switched on
unattended.
Children should be supervised to
make sure they do not play with the
tool.
First time of use
A small quantity of smoke may occur
when the tool is used for the first
time. This smoke is caused by bind-
ing agents released from the heater's
insulating film during the first time of
use.
About this document
Please read carefully and keep in a safe place.
– Under copyright. Reproduction either in whole or in
part only with our consent.
– Subject to change in the interest of technical progress.
To let the smoke escape quickly, the
tool should be set down on its stand-
ing surface. The area you are working
in should be well ventilated when using
the tool for the first time. Any smoke
coming out of the tool is not harmful!
Risk of electric shock!
230 V means danger to life!
• Disconnect the power supply before
attempting any work on the tool.
• Check the tool for any damage
(power cord,
housing etc.) before putting it into
operation and do not use the tool
if it is damaged.
• Do not expose electric power tools
to rain. Do not use electric power
tools if they are damp and do not
use them in a damp or wet environ-
ment.
• Avoid coming into contact with
earthed objects, such as pipes,
radiators, cookers or refrigerators.
• Do not carry the tool by the power
cord and do not unplug the tool by
pulling on the power cord. Protect
the power cord from heat, oil and
sharp edges.
8