Black and Decker BEBLV301 Manual Del Usuario página 11

Do not expose the tool to rain or
high humidity or leave outdoors
while it is raining.
Switch off: remove plug from
mains before cleaning or mainte-
nance.
Disconnect the mains plug if
the cord becomes damaged or
entangled.
Beware of flying objects.
Keep bystanders away.
Directive 2000/14/EC guaran-
teed sound power.
Features
This appliance includes some or all of the following features.
1. On/Off switch - speed control
2. Front handle
3. Adjustable back handle
3a. Adjustable back handle release button
3b. Additional strap
4. Power head
5. Upper vacuum tube
6. Lower vacuum tube
6a. Rake
7. Upper blower tube
8. Lower blower tube
9. Concentrator
10. Collection bag
11. Bag connector
Using your product
Warning! When using as a blower or vacuum, always wear
safety glasses. If using in dusty conditions, wear a filter mask
as well.
Warning! Switch off your product, allow the fan to stop and
remove the plug from the socket before carrying out any
adjustment, servicing or maintenance.
Assembly
Warning! Before assembly, make sure that the
appliance is switched off and unplugged.
(Original instructions)
Warning! Always wear protective gloves when
working with your blow vac.
Vacuum tube assembly (fig. A)
The vacuum tubes must be assembled together before use.
Warning! Do not operate the appliance with the vacuum
tubes separated.
To ease assembly, apply a soapy water solution to the
u
joint area.
Align the notches (5a) and the recesses (6a) on the upper
u
(5) and lower (6) vacuum tubes.
Push the lower vacuum tube (6) firmly onto the upper
u
vacuum tube (5) until they click into place.
Warning! Do not separate the tubes once assembled.
Vacuum mode (fig. B, C, D, E, F, G, H, I, J, K, L, M,
N, O, P, Q, R)
Rotate the fan guard assembly anti-clockwise (fig. B).
u
Insert the rod (14) (supplied) into the fan guard release
u
(13) and push upward to release the fan guard assembly
(12) as shown in figure C.
Drop the fan guard assembly (12) forward as shown in
u
figure D.
Insert the assembled vacuum tube (5) into the available
u
recess in the power head (4) as shown in figure E.
Rotate the assembled vacuum tube clockwise so that the
u
bayonet fixing locks into place as shown in figure E.
Insert the collection bag connector (11) onto the power
u
head receptacle (11a) as shown in figure F.
Place the straps from the collection bag (10) over your
u
shoulders (fig. G) this will support the additional weight as
the back pack collection bag fills.
Fitting and removing the rake (fig. H)
Position the rake (6a) above the mount (6c) on the bottom
u
of the lower blow tube (6).
Push down and slide the rake (6a) firmly onto the mount
u
(6c) until it clicks into place.
To remove, lift the rake release (6b) and slide the rake
u
(6a) off the mount (6c).
Adjusting the position of the back handle (fig. I)
The back handle (3) can be adjusted to provide optimum
balance and comfort.
Press in the release button (3a) on the left side of the back
u
handle.
Rotate the back handle (3) into the required position.
u
Release the button (3a).
u
Warning! Ensure that the teeth on the button are correctly
aligned in slots in the handle and that the handle is secure.
Position the vacuum tube slightly above the debris/leaves.
u
ENGLISH
11