DeWalt DC820 Manual De Instrucciones página 9

Destornillador de impacto inalambrico de 6,35 mm (1/4'') llave de impacto inalambrica de 9,5 mm (3/8'') llave de impacto inalambrica de 18 v y 13 mm (1/2'')
Ocultar thumbs Ver también para DC820:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2.Insert thebattery pack (M) i nto thecharger, asshown i nFigure 1 ,
making sure the pack isfully s eated incharger. The red(charging)
light w ill b link continuously
indicating thatthecharging process
has started.
3.Thecompletion of charge w illbe indicated by theredlight
remaining
oncontinuously.
The pack isfully charged and may be
used a tthis time orleftinthe charger.
FIG. 1
Indicator
Light
Operation
PACK CHARGING ...................
=== === === === === === === === ===
PACK CHARGED .....................
HOT/COLD
PACK DELAY ........ _
[] _
[] _
[]
REPLACE
PACK ......................
® ®®®®®®®®OOOO®®
PROBLEM
POWER LINE ........ ® ®
® ®
®
® ®
Charge
Indicators
Some chargers are designed to detect certain problems that can arise
with battery packs. Problems are indicated by the red light flashing
at a fast rate. If this occurs, re-insert battery pack into the charger. If
the problem persists, try a different battery pack to determine if the
charger is OK. If the new pack charges correctly, then the original
pack is defective and should be returned to a service center or
other collection site for recycling. If the new battery pack elicits the
same trouble indication as the original, have the charger tested at an
authorized service center.
HOT/COLD PACK DELAY
Some chargers have a Hot/Cold
Pack Delay feature: when the
charger detects a battery that is hot, it automatically starts a Hot Pack
Delay, suspending charging until the battery has cooled. After the
battery has cooled, the charger automatically switches to the Pack
Charging mode. This feature ensures maximum battery life. The red
light flashes long, then short while in the Hot Pack Delay mode.
PROBLEM POWER LINE
Some chargers have a Problem Power Line indicator. When the
charger
is used with
some
portable power sources
such as
generators or sources that convert DC to AC, the charger may
temporarily suspend operation, flashing the red light with two
fast blinks followed
by a pause. This indicates the power source
is out of limits.
LEAVING THE BATTERY PACK IN THE CHARGER
The charger and battery pack can be left connected with the red light
glowing indefinitely. The charger will keep the battery pack fresh and
fully charged.
NOTE: A battery pack will slowly lose its charge when kept out of
the charger. If the battery pack has not been kept on maintenance

Publicidad

Tabla de contenido
loading

Tabla de contenido