Start Up Guide; Checking The Contents; Printer Installation - DNP DP-DS620 Guia De Inicio Rapido

Start Up Guide

Checking the contents

Printer unit
Power cord

Printer installation

1
Connect the power cord
(supplied) and the USB
cable, and make sure that
the ON/Standby switch of
the printer is turned ON.
2
Use the opening lever to
open the lock, and then
pull out the mechanism
unit.
3
Lift the paper lever, raise the front
cover and remove the scrap box.
Paper lever
Front cover
4
Remove the paper holder
from the printer.
5
Set the paper roll on
the paper holder.
Set the roll so that
there is no gap
between the paper
and the holder.
6
Set the paper holder in
the printer, and then
rotate the roll in the
direction of the arrow.
Insert the leading edge
of the paper until you
hear the buzzer sound.
The flashing LED
(orange) turns off.
Ribbon
cassette
Paper tray
(for L and PC sizes)
ON/Standby
switch
Opening lever
Scrap box
Hold the paper holder to
prevent it from turning
when rotating the paper.
Before using the product, read "For Safe Operation" carefully.
Paper holder
L size spacer
7
Set the scrap box and
close the front cover.
Caution
Make sure that the scrap box is installed when printing.
If not installed, your fingers may get caught in the moving
parts and be injured.
8
Remove the ribbon
cassette from the
printer unit.
9
Set the new ribbon into
the ribbon cassette.
Rotate the roller in the
direction of the arrow
to take up the slack.
10
Install the ribbon
cassette to the printer
unit.
Install the cassette so
that the supply side is
at the front.
11
Close the mechanism
unit.
When the mechanism unit is closed, the printer starts
paper initialization. (Five blank sheets are output.) Paper
initialization cuts off the outer layer of the paper that may
be dirty. Note that paper initialization is not carried out if
the printer ON/Standby switch is set to ON after the paper
is set.
12
Install the printer driver.
For more information, refer to "Printer Driver User's
Manual" including in the supplied CD-ROM.
13
Connect the printer to the computer with a USB
cable.
Paper tray installation
When using L or PC size paper, you may install the paper
tray to the scrap box.
Scrap box
CD-ROM
Printer Driver User's Manual
Explanation booklet (this document)
For Safe Operation
Start up guide
Take-up
side
Supply
side
Paper tray