Start Up Guide; Checking The Contents; Printer Installation - DNP DS-621 Guía De Inicio

Start Up Guide

Checking the contents

Printer unit

Printer installation

Make sure the power cord
1
(supplied) and the USB
cable are connected and
the ON/Standby switch of
the printer is set to ON.
Use the opening lever to
2
open the lock, and then
pull out the mechanism
unit.
Lift the paper lever, raise the front cover
3
and remove the scrap box.
Paper lever
Front cover
Remove the paper holder
4
from the printer.
Set the paper roll on the
5
paper holder.
Set the roll so that there
is no gap between the
paper and the holder.
Set the paper holder in the
6
printer, and then rotate
the roll in the direction of
the arrow. Insert the
leading edge of the paper
until you hear the buzzer
sound.
The flashing LED (orange)
turns off.
Before using the product, read "For Safe Operation" carefully.
Power cord Ribbon cassette
ON/Standby
switch
Opening lever
Scrap box
Hold the paper holder to
prevent it from turning
when rotating the paper.
Paper holder
Set the scrap box and
7
close the front cover.
Remove the ribbon
8
cassette from the printer
unit.
Set the new ribbon into
9
the ribbon cassette.
Rotate the roller in the
direction of the arrow
to take up the slack.
Take-up
side
Install the ribbon cassette
10
to the printer unit.
Install the cassette
so that the supply
side is at the front.
Close the mechanism unit.
11
Note : When the mechanism unit is closed, the printer starts
paper initialization. (Five blank sheets are output.) Paper
initialization cuts off the outer layer of the paper that may be
dirty. Note that paper initialization is not carried out if the
printer ON/Standby switch is set to ON after the paper is set.
DIGITAL PHOTO PRINTER
DP-DS621
User's Manual
Dai Nippon Printing Co., Ltd. Version 0.20
Explanation booklet
(this document)
For Safe Operation
Start up guide
Supply
side