Remington SF4880 Manual Del Usuario página 5

ENGLISH
, TRIMMING
• Slide the trimmer release button down to activate the trimmer.
• Hold the trimmer at a right angle to your skin.
• To retract the trimmer, push the top rear of the trimmer down until it locks
under the trimmer release button.
, SHAVING WITH SHAVING GEL OR FOAM
• Follow the same instructions as dry shaving if using shaving gel.
, Caution: After use with shaving gel, please ensure the head and cutters are
rinsed under warm water to clean away any excess gel and debris.
E TIPS FOR BEST RESULTS
• Always hold the shaver at right angles to the skin so that the shave head is
touching the skin with equal pressure.
• Use moderate to slow stroking movements. The use of short linear motions in
stubborn areas may obtain a closer shave, especially along the neck and chin
line.
• DO NOT press hard against the skin in order to avoid irritation and damage
to the intercept heads.
C CARE FOR YOUR SHAVER
• To ensure long lasting performance clean after each use.
• Ensure the appliance is switched off and unplugged from the mains.
, DRY CLEANING
• Pull the shave head assembly up to remove from the hair pocket.
• Gently tap out the excess hair shavings and use a cleaning brush to clean
out the hair pocket if necessary.
• Do not use a brush to clean the shaving intercept trimmers.
• Replace the head assembly.
, WASHABLE CLEANING
• The easiest and most hygienic way to clean the appliance is by rinsing the
appliance head after use with warm water.
• Pull the shave head assembly up to remove from the hair pocket.
• Do not use the brush to clean the intercept trimmers but blow the shavings
out or rinse in running water.
• Replace the head assembly once dry.
• Lubricate the teeth of the trimmer every six weeks with a drop of sewing
machine oil.
5