The Genius 2D has two (2) automatic modes, and will begin charging when both the battery and power are connected. Do not operate the charger until you confirm

the Genius 2D charger is compatible with your battery type and voltage. Below is a brief description:

Mode

Explanation

The charger is connected to AC power but no battery is detected, and the charger is not charging. Energy Save is activated during this mode,

drawing microscopic power from the electrical outlet.

Standby

No Power

For charging 12-volt Wet Cell, Gel Cell, Enhanced Flooded, Maintenance-Free, Calcium batteries and AGM.

12V NORM

14.5V | 2000mA | Up To 40Ah Batteries | Maintain all sizes

On-Board Mounting.

Mount the charger near the battery, ensuring the cables and charger are secure and away from any moving parts (eg. fan blades, belts, pulleys). Secure the

provided mounting bracket to the vehicle's chassis using the two included self-tapping screws. For best results, mark the position using the bracket, and pre-drill

two small pilot holes. Once the bracket is secured, use the velcro strap to secure the Genius 2D in place.

Connecting to the Battery.

Do not connect the AC power plug until all other connections are made. Identify the correct polarity of the battery terminals on the battery. Do not make any

connections to the carburetor, fuel lines, or thin, sheet metal parts. The below instructions are for a negative ground system (most common). If your vehicle is a

positive ground system (very uncommon), follow the below instructions in reverse order.

1.) Connect the positive (red) eyelet terminal connector to the positive (POS,P,+) battery terminal.

2.) Connect the negative (black) eyelet terminal connector to the negative (NEG,N,-) battery terminal.

3.) Connect the battery charger's AC power plug into a suitable electrical outlet.

Tabla de Contenido