Troubleshooting; Maintenance - Porter Cable 548 Manual De Instrucciones

C. Lift off cover and gasket being careful not to damage the gasket.
D. There should be a thin layer of lubricant around the blade holder. If this
lubricant is contaminated, take your saw to an authorized Porter-Cable
Service Station for a thorough cleaning and lubrication. If lubricant is
needed, brush a thin coat of Porter-Cable lubricant on the blade holder.
NOTE: An excessive amount of lubricant may leak through the blade
holder dust seal and spatter on material being cut.
E. Replace gasket and gear housing cover and tighten four screws
securely.
For assistance with your tool, visit our website at www.porter-cable.com for a
list of service centers or call the Porter-Cable help line at 1-800-487-8665.
KEEP TOOL CLEAN
Periodically blow out all air passages with dry compressed air. All plastic parts
should be cleaned with a soft damp cloth. NEVER use solvents to clean plastic
parts. They could possibly dissolve or otherwise damage the material.
FAILURE TO START
Should your tool fail to start, check to make sure the prongs on the cord plug are
making good contact in the outlet. Also, check for blown fuses or open circuit
breakers in the line.
BRUSH INSPECTION
For your continued safety and electrical protection, brush inspection and
replacement on this tool should ONLY be performed by an AUTHORIZED
PORTER-CABLE SERVICE STATION or a PORTER-CABLE
FACTORY SERVICE CENTER.
At approximately 100 hours of use, take or send your tool to your nearest
authorized Porter-Cable Service Station to be thoroughly cleaned and inspected.
Have worn parts replaced and lubricated with fresh lubricant. Have new brushes
installed, and test the tool for performance.
Any loss of power before the above maintenance check may indicate the need
for immediate servicing of your tool. DO NOT CONTINUE TO OPERATE TOOL
UNDER THIS CONDITION. If proper operating voltage is present, return your tool
to the service station for immediate service.

TROUBLESHOOTING

MAINTENANCE

Wear ANSI Z87.1 safety glasses while using compressed
air.
(If applicable)
12
·
DELTA